5–3
Communications Parameters Summary (continued)
Parameter Description Range Default
P9.24
Block Transfer Parameter 14 P0.00 to P8.02, P9.99 P9.99
P9.25
Block Transfer Parameter 15 P0.00 to P8.02, P9.99 P9.99
P9.26
Serial Comm (RS485) Speed Reference 0.0 to 400.0 Hz 60.0
P9.27
Serial Comm RUN Command
00: Stop
01: Run
00
P9.28
Serial Comm Direction Command
00: Forward
01: Reverse
00
P9.29
Serial Comm External Fault
00: No fault
01: External fault
00
P9.30
Serial Comm Fault Reset
00: No action
01: Fault Reset
00
P9.31
Serial Comm JOG Command
00: Stop
01: Jog
00
P9.39**
Firmware Version #.## #.##
P9.40
Parameter Copy
00: Disable Copy Keypad Function
01: Enable Copy Keypad Function
00
P9.41
GS Series Number
01: GS1
02: GS2
03: GS3
04: GS4
##
P 9.42
Manufacturer Model Information
00: GS3-21P0 (230V 3ph 1.0hp)
01: GS3-22P0 (230V 3ph 2.0hp)
02: GS3-23P0 (230V 3ph 3.0hp)
03: GS3-25P0 (230V 3ph 5.0hp)
04: GS3-27P5 (230V 3ph 7.5hp)
05: GS3-2010 (230V 3ph 10hp)
06: GS3-2015 (230V 3ph 15hp)
07: GS3-2020 (230V 3ph 20hp)
08: GS3-2025 (230V 3ph 25hp
09: GS3-2030 (230V 3ph 30hp)
10: GS3-2040 (230V 3ph 40hp)
11: GS3-2050 (230V 3ph 50hp)
12: GS3-41P0 (460V 3ph 1.0hp)
13: GS3-42P0 (460V 3ph 2.0hp)
14: GS3-43P0 (460V 3ph 3.0hp)
15: GS3-45P0 (460V 3ph 5.0hp)
16: GS3-47P5 (460V 3ph 7.5hp)
17: GS3-4010 (460V 3ph 10hp)
18: GS3-4015 (460V 3ph 15hp)
19: GS3-4020 (460V 3ph 20hp)
20: GS3-4025 (460V 3ph 25hp)
21: GS3-4030 (460V 3ph 30hp)
22: GS3-4040 (460V 3ph 40hp)
23: GS3-4050 (460V 3ph 50hp)
24: GS3-4060 (460V 3ph 60hp)
25: GS3-4075 (460V 3ph 75hp)
26: GS3-4100 (460V 3ph 100hp)
##
** Some parameters are available only in later firmware versions of DURAPULSE drives. Refer to
“DURA
PULSE Parameter Summary” in Chapter 4 (AC Drive Parameters) for more information.
Parameter can be set during RUN Mode.
Chapter 5: DURAPULSE MODBUS Communications
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013
To Next Page
Loading...