AutomationDirect DURAPULSE Series - Control Wiring Diagram - Sinking Inputs

2–21
Control Wiring Diagram – Sinking Inputs
Control circuit terminal Shielded leads Main circuit (power) terminals
DURAPULSE
AC Drive
GS3-xxxx
+24V Power Source
(20mA max.)
DI2
DI1
R1O
R1
R1C
DI4
DI3
Sink
Source
SW1
Input Mode Setting
Sink
DI5
DI6
DI7
DI8
DI9
DI10
DI11
DCM
Digital Signal Com.
+10V Power Source
(20mA max.)
AI1
(0 to 10V)
AI2
(0-20mA or 4-20mA)
AI3
(-10 to +10V)
ACM
Analog Signal Common
1 6
Forward/Stop
Reverse/Stop
External Fault (N.O.)
Multi-Speed 1
Multi-Speed 2
Multi-Speed 3
Multi-speed 4
JOG
External Reset
Second Accel/Decel Time
External Base Block (N.O.)
DO1
DO2
DO3
AO
FO
Multi-function Output Contact:
240VAC/24VDC@3A Resistive (N.C.)
240VAC/24VDC@0.5A Inductive (N.C.)
AC Drive Running
Multi-function Digital Outputs:
Multi-function Digital Inputs:
12-48VDC @50mA
AC Drive Fault
At Speed
Zero Speed
Potentiometer
5k
Analog Inputs:
DOC
12-48VDC @50mA
12-48VDC @50mA
Digital Frequency Output:
RS-485 Serial Comm Port:
Digital Output Com.
DCM
ACM
1:1, Duty = 50%
1: +15V
2: GND 4: SG+
3: SG- 5: NC
Frequency command source
can be one of the three analog
inputs, up/down keys on keypad
or via the RS-485 serial comm
port. See parameter settings.
See Power
Wiring Diag.
See Power
Wiring Diagram
 Factory default source of frequency command is via the keypad up/down keys
 Factory default setting

†
†
†
†
†
†
48VDC @50mA max.
Multi-function Analog Output:
+
-
Output Frequency indication
0-10 VDC @ 2mA
Voltmeter
 ACM and DCM are isolated from each other
+
-
12-48VDC
240VAC/24VDC@5A Resistive (N.O.)
240VAC/24VDC@1.5A Inductive (N.O.)
WARNING: Do not plug a modem or telephone into the DURAPULSE RJ-12 Serial
Comm Port, or permanent damage may result.
Users must connect wiring according to the circuit diagram shown below.
Chapter 2: Installation and Wiring
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013