AutomationDirect DURAPULSE Series - Programming the DURAPULSE AC Drive

3–5
Programming the DURAPULSE AC Drive
The DURAPULSE AC Drive parameters are organized into eleven (11) different groups
according to their functions, plus a special “Copy Keypad” function for storing up to
four (4) different sets of program parameters into the keypad. The illustration below
shows you how to navigate through the parameter groups and parameter settings. For
a complete list of parameters, see C
HAPTER 4.
RAMPS GROUP
P1.00 - P1.22
MOTOR GROUP
P0.00 - P0.07
V/HZ GROUP
P2.00 - P2.10
DIGITAL GROUP
P3.00 - P3.30
ANALOG GROUP
P4.00 - P4.12
PRESETS GROUP
P5.00 - P5.15
PROTECT GROUP
P6.00 - P6.36
PID GROUP
P7.00 - P7-27
DISPLAY GROUP
P8.00 - P8.02
PROGRAM
PROGRAM
ENC FBACK GROUP
P10.00 - P10.05
COMMS GROUP
P9.00 - P9.42
MOTOR P0.01
MOTOR AMPERAGE
MOTOR P0.02
MOTOR FREQUENCY
MOTOR P0.03
MOTOR BASE RPM
MOTOR P0.04
MOTOR MAX RPM
MOTOR P0.05
MOTOR AUTO-TUNE
MOTOR P0.06
MOTOR RESISTANCE
MOTOR P0.07
MOTOR NO LOAD
1
Select Parameter Group
MOTOR P0.00
MOTOR VOLTAGE
3
Select Parameter
ENTER
ENTER
MOTOR FREQUENCY
P0.02 = 400 Hz
MOTOR FREQUENCY
P0.02 = 60 Hz
MOTOR FREQUENCY
P0.02 = 50 Hz
ENTER
ENTER
5
Select Parameter Value
4
ENTER
ENTER
6
Value Accepted
7
2
 Press the PROGRAM key and then use the UP/DOWN or
PROGRAM keys to cycle through the parameter groups. The LCD
display will show the parameter group that is currently selected.
  Press the ENTER key to display the various parameters for the
selected group and use the UP/DOWN keys to view each one.
 When the desired parameter is shown, press the ENTER key to
select.
 Use the UP/DOWN keys to cycle through the available settings.
 Press the ENTER key to select the
setting. The phrase “Value
Accepted” will be displayed for a
moment to show that the
parameter value has been
changed.
 After the parameter value has been
set, the LCD display will cycle to
the next parameter in the selected
group.
Chapter 3: Keypad Operation and Quickstart
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013