Appendix A: Accessories
DURA
PULSE AC Drive User Manual
A–46
ZIPLink™ Cables for RS-485 Modbus RTU
ZIPLink communication cables make it very easy to set up RS-485 Modbus RTU
control of a single DURA
PULSE AC drive from a DirectLOGIC DL06 or D2-260
PLC.
In addition to these GS-specific cables, the ZIPLink product line also includes other
components which can be useful for Modbus wiring, including distribution modules for
wiring connections to multiple drives.
For more information, refer to Ch5 “GS1 Modbus Communications” or to
www.automationdirect.com/static/specs/fzipselection.pdf.
PLC Connections for RS-485 Modbus RTU Control of DURAPULSE Drive
Drive
PLC *
or Device
PLC
Port *
Communication Direct Cable Length
DURAPULSE (GS3)
CLICK 3 RS-485 ZL-RJ12-CBL-2P *** 2m [6.6 ft] ***
DL05 2 ** RS-232 – RS-485 ** N/A **
DL06
D0-DCM
2 RS-485
GS-485HD15-CBL-2 ***
2m [6.6 ft] ***
D2-DCM
D2-250(-1)
2 ** RS-232 – RS-485 ** N/A **
D2-260 2 RS-485
GS-485HD15-CBL-2 ***
2m [6.6 ft] ***
D4-450 3 ** RS-232 – RS-485 ** N/A **
FA-ISOCON RS-485
GS-ISOCON-CBL-2
2m [6.6 ft] ***
GS-EDRV100 RS-485
GS-EDRV-CBL-2
2m [6.6 ft] ***
ZL-CDM-RJ12Xxx RS-485
GS-485RJ12-CBL-2
2m [6.6 ft] ***
* If a PLC type or port is not listed in this chart, it cannot function as a Modbus RTU master.
** Requires RS-232–RS-485 converter & generic cabling options described in Ch5 “GS1 Modbus
Communications”.
*** Termination resistors not required due to short cable length.
GS-485HD15-CBL-2
1st Ed. Rev. D 05/2013
To Next Page
Loading...