5–13
Output Voltage U (XXX.X) h2106
Status location for the output voltage present at the T1, T2, and T3 terminals.
Motor RPM h2107
Status location for the present estimated speed of the motor.
Scale Frequency (Low word) h2108
Status location for result of output frequency x P 8.01 (low word).
Scale Frequency (High word) h2109
Status location for result of output frequency x P 8.01 (high word).
Power Factor Angle h210A
Status location for the power factor angle.
% Load h210B
Status location for the amount of load on the AC drive. (Output Current ÷ Drive
Rated Current) x 100.
PID Setpoint h210C
Status location for the PID setpoint.
PID Feedback Signal (Process Variable) h210D
Status location for PID process variable feedback signal.
Firmware Version h2110
Status location for the firmware version of the AC drive.
Chapter 5: DURAPULSE MODBUS Communications
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013
To Next Page
Loading...