Autonics CT6M-1P4 - Communication Address; Communication Speed; Communication Parity Bit

9 Communication
78 © Copyright Reserved Autonics Co., Ltd.
9.1.1 Communication address [
ADDR
]
When communicating with upper host, set the address to designate each unit by upper host.
When communicating with multi units with same address, it does not operate normally.
Setting range of communication address is 1 to 127.
 key: To shift flashing digits of comm. address.

,
key: To change the flashing digits.
When communication address is set as 23,
9.1.2 Communication speed [BPS]
When communicating with upper host PC, set the communication speed.
9.1.3 Communication parity bit[PRTY]
Set communication parity bit as none [NONE], even [EVEN], or odd[ODD].