Page - 20
Pool Cover Detection
The ChlorSync
®
can support the addition of an automatic pool cover switch (not supplied) that
will detect when the pool cover is open or closed. The ChlorSync
®
will automatically adjust
sanitizer output when the cover is closed, avoiding over chlorination or premature cell depletion.
This feature will recognize a signal from the cover switch that is a dry contact connected directly
to the power center board. When the pool cover is detected (via the pool cover switch), the unit
will automatically reduce the sanitizer output to 5% of the user setting.
Note: The display will continue to show original sanitizer output that was set by the user.
Terminal Connector Location
Figure 10
PoolSync
TM
Installation (optional equipment not included)
The PoolSync
TM
is an optional device that allows the user to view and
control the ChlorSync
®
via the mobile PoolSync
TM
app. Key features of the
PoolSync
TM
include:
l Monitor and control purifier output percentage remotely
l Advise as to how much salt to add, when needed
l Monitor current salt level, flow and water temperature
l Notification should the unit need any attention
For more detailed information on features and how to use the app, please
see the manual included with your PoolSync
TM
product. Follow the wiring
diagrams provided to connect the PoolSync
TM
unit to the power center.
To Next Page
Loading...
Need help?
General
