Autopilot Pool Pilot Digital Nano - Set Purifier Off Feature

Page - 25
7.7.e Set Purifier Off
The Digital Nano / Nano+ system can be programmed to delay chlorine production if salt will not
be added to the pool water for a specified amount of time, from 1-28 days. The system will
automatically start up in the Purifier mode after the user defined time has expired. This feature
can be used when starting up a newly constructed or resurfaced pool when salt is not going to
be added for a few days. The unit will display normal operating messages, including salt levels,
but will not show error messages related to chlorine production or salt levels.
1.
Press MENU, press △ or▽ until “Installer menu” is displayed, then press and hold SELECT for
approximately 13 seconds to enter the Installer menu.
2.
Press △ or▽ until “Purifier Off” is displayed, then press SELECT.
3.
Press △ or▽ until the desired amount of days “## Day(s)” is displayed and then press SELECT.
4.
The display will flash “Purifier Off; ## Day(s)” three times and then display the next menu option.
5.
Press △ or▽ until “End menu mode” is displayed, then press SELECT.
The system will now begin to count down and will not generate chlorine until the amount of time
chosen has expired.
To turn this feature off before the designated time has elapsed:
1.
Press MENU, press △ or▽ until “Installer menu” is displayed, then press and hold SELECT for
approximately 13 seconds to enter the Installer menu.
2.
Press △ or▽ until “Purifier Off” is displayed, then press SELECT.
3.
The days remaining will be displayed. Press △ or▽ until “0 Day(s)” appears, then press SELECT.
4.
Press △ or▽ until “End menu mode” is displayed, then press SELECT.