Page 14
Before You Start
• [OBD-II] Your scanner must be connected, and the key in the ON
position, before viewing OBD-II Readiness Test data. If MON is
pressed, and the vehicle has not been scanned, the scanner will
display Press the Scan key to Scan New Data. Refer to
“Scanning the Vehicle” on page 12.
1. Press POWER to display the EZ-Read scanner opening
screen.
2. Press MON to display Monitor menu.
Use the
pand qarrow keys until 3-
Readiness Test
is highlighted, then
press
ENTER.
3. The name of the Readiness Test will be
displayed, followed by its status. Status is
either Completed, Not Completed, or Not
Supported.
• A down arrow on the screen indicates other test results.
Use the
pand qarrow keys to view these other test
results.
The following Readiness Tests are supported by the scanner:
CONTINUOUS NON-CONTINUOUS
Misfire Monitoring Catalyst Monitoring
Fuel System Monitoring Heated Catalyst Monitoring
Comprehensive Evaporative System Monitoring
Component Monitoring Secondary Air System Monitoring
A/C System Refrigerant Monitoring
O2 Sensor Monitoring
O2 Sensor Heater Monitoring
EGR System Monitoring
4. Press MON to exit the Readiness Test and display the opening
screen.
READINESS TEST - OBD-II
To Next Page
Loading...