Page 16
Use the pand qarrow keys to view the additional text.
• Use the
tand uarrow keys to view any other
Trouble Codes.
CLEAR THE CODES - OBD-II, GM, CHRYSLER OBD-I
Before You Start
• Clearing Trouble Codes will remove any Trouble Codes from
the vehicle’s computer. You can use this feature to make
sure vehicle repairs were done correctly by doing
a new scan after clearing the codes.
• Your vehicle must be scanned before clearing trouble codes.
If
DATA is pressed, and the vehicle has not been
scanned, the EZ-Read will display
Press the Scan
key to Scan New Data
. Refer to “Scanning the
Vehicle” on page 12.
Clearing Trouble Codes
1. Make sure the EZ-Read EZ-Read cable is correctly connected to
the EZ-Read and to the vehicle, the
engine is OFF, and the vehicle ignition
key is ON, then press
POWER.
2. [OBD-II] Use the pand qarrow keys
until
4-Clear Data is highlighted, then
press
ENTER.
3. ENTER to Clear will be displayed on the screen. Press
ENTER to clear all the codes in the vehicle’s computer.
(Pressing
DATA again will take the unit out of Data mode and
display the opening screen.)
4. After the codes have been cleared, Function Successful
will be displayed. Press DATA to display the opening screen.
VIEW THE TROUBLE CODES - OBD-II, GM, CHRYSLER OBD-I (CONT.)
To Next Page
Loading...