UPGRADE, UPDATE, SPECIFICATIONS
Page 28
This section contains information about the following subjects:
• EZ-Read Upgrade - Adding Capability (Phone or Internet)
• EZ-Read Update - Loading New Software Version
• System Information
• Set the Time Units for Capture Mode
• Technical Description of OBD-I and -II
EZ-Read Upgrade - Adding Capability (Phone or Internet)
Upgrading the EZ-Read involves enabling features in your EZ-
Read. If you have a GM, FORD,
Chrysler, or OBD-II EZ-Read, you can add any of the other
ver-
sions to your EZ-Read for a nominal charge by simply calling
AutoXray. One of our Customer Service Representatives will step
you through the process (see our web site or contact AutoXray for
current prices).
Do the following to UPGRADE your EZ-Read:
1. Press CONFIG from the initial screen.
2. Use the pand qkeys to display 3-User Upgrade on the
screen, then press
ENTER.
3. Write down the Serial Number for your EZ-Read software, then
press
ENTER.
4. Use the pand qarrows until the vehicle application you want
to add is displayed, then press
ENTER.
5. Write down the Seed Number that is displayed on the screen.
The Seed Number is used by AutoXray to generate a unique
Upgrade Key for your EZ-Read.
6. Call AutoXray at 480.804.1673 and tell the Customer Service
Representative the vehicle application you want to add.
AutoXray will ask for your software serial number and seed
To Next Page
Loading...