Before You Start
• Your scanner must be connected, and the key in the ON
position, before viewing OBD-II Readiness Test data. If
MON is pressed, and the vehicle has not been scanned,
the scanner will display
Press the Scan key to
Scan New Data
. Refer to “Scanning the Vehicle” on
page 47.
1. Press POWER to display the EZ-
Read scanner opening screen.
2. Press MON to display Monitor
menu. Use the
pand qarrow keys
until
3-Readiness Test is highlight-
ed, then press
ENTER.
3. The name of the Readiness Test will be displayed, followed by
its status. Status is either Completed, Not Completed, or Not
Supported.
• A down arrow on the screen indicates other test results.
Use the
pand qarrow keys to view these other test
results.
The following Readiness Tests are supported by the scanner:
CONTINUOUS NON-CONTINUOUS
Misfire Monitoring Catalyst Monitoring
Fuel System Monitoring Heated Catalyst Monitoring
Comprehensive Evaporative System Monitoring
Component Monitoring Secondary Air System Monitoring
A/C System Refrigerant Monitoring
O2 Sensor Monitoring
O2 Sensor Heater Monitoring
EGR System Monitoring
4. Press MON to exit the Readiness Test and display the opening
screen.
Page 48
READINESS TEST
To Next Page
Loading...