AVA WEIGH 334BS30 - Operations and Settings; Normal Weighing Mode; Zero Function; Tare Function

8.
1. Power on the scale by pressing the ZERO/ON/OFF key.
2. If the display stabilizes but doesn’t show zero, press the ZERO/ON/OFF key to set new zero point.
3. Place the objects on the scale platform and read the weight on the indicator.
Note: Objects should be placed at the center of the platform. Corner or side loading heavy
objects may risk overloading an individual load cell and damage the scale.
4. To change the weight unit of measure, press the UNIT/DATA key.
5. To send data to another device via the serial port, press the PRINT/FUNC key.
6. Power off the scale by pressing the ZERO/ON/OFF key for 4 seconds.
1. Zero the scale as described above.
2. Place an empty container on the platform, press the TARE/PRESET key. The display will return to
zero, eliminating the weight of the container. NET will be lit on the display.
3. Place the material or object to be weighed in the container. The net weight will be displayed.
4. To exit tare mode, remove all weight from the scale. The display will show a negative weight. Press
the TARE/RESET key to return the display to zero.
1. Zero the scale as described above.
2. Press and hold the TARE/PRESET key until is displayed, then the tare weight will be
displayed. The first digit and NET will flash in the display.
3. Input the tare weight using the ↑↓→keys. After inputting the tare weight, press the TARE/PRESET
key to confirm. NET will be lit in the display.
Note:Tare weight must be greater than zero and no more than the scale’s max capacity.
4. Place the material or object to be weighed onto the scale platform. The net weight will be displayed.
5. To exit tare mode, remove all weight from the scale. The display will show a negative weight. Press
the TARE/RESET key to return the display to zero.
Note: The indicator can only save 1 tare weight. Entering a new tare weight will automatically replace
the old one.
Note: Pre-set tare weight will be lost after the scale is powered off.
OPERATIONS & SETTINGS
NORMAL WEIGHING MODE
YES NO NO
TARE FUNCTION
This scale allows for both a manually entered pre-set tare weight, as well as a “weighed” tare weight.
WEIGHED TARE
PRE-DETERMINED TARE
1. If the display does not show 0, and there is no object on the platform, press the ZERO/ON/OFF key
to zero the reading.
• Zero range: ±2% * full capacity.
• The zero function is unavailable when the displayed reading is out of the zero range and the indicator
will show the error message or meaning the scale is over or under the zero range.
ZERO FUNCTION