5. Perform the following actions to install the system in the rack:
a. Pull the inner slide rails out of the rack until they lock into place.
b. Locate the rear rail standoff on each side of the system and lower them into the rear
J-slots on the slide assemblies.
c. Rotate the system downward until all the rail standoffs are seated in the J-slots.
d. Push the system inward until the lock levers click into place. Press the slide-release
lock buttons on both rails and slide the system into the rack
Installation
December 2018 Installing the Avaya Converged Platform 120 Series 22
Comments on this document? infodev@avaya.com
To Next Page
Loading...
