Figure 5: ERS 3549GTS and ERS 3549GTS-PWR+ rear ports
Figure 6: ERS 3550T and ERS 3550T-PWR+ rear ports
For more information, see Quick Start Configuration for Avaya Ethernet Routing Switch 3500 Series,
NN47203-301.
Stacking cables must be ordered separately. The correct Avaya SFP direct attach cable is required
in order to enable and use stacking mode. For more information see,
Cable requirements on
page 22.
Connecting switches in a stack
Cascading down or cascading up ports
About this task
Connect a switch to the next unit in the stack through a cascade cable.
The stack parameters are associated with the base unit, the physical stack order depends on the
base unit position and whether you configure the stack cascade up (stack up) or cascade down
(stack down). This designation depends on the stack cabling arrangement.
Installing the Avaya Ethernet Routing Switch 3500 Series
September 2016 Installing Avaya Ethernet Routing Switch 3500 Series 38
Comments on this document? infodev@avaya.com
To Next Page
Loading...
