Connecting the AC power cord to the switch
About this task
Connect a switch to a power source.
Before you begin
• Ensure to check AC power specifications for the switch.
• Ensure to check the AC power cord for international use. You must use a power cord that is
approved for the receptacle type in your country.
For more information see,
AC power specifications on page 43.
Procedure
1. Connect the AC power cord to the back of the switch, and then connect the cord to a power
outlet.
Note:
ERS 3500 does not have a power switch. When you connect the AC power cord to a
suitable AC power outlet, the switch powers up immediately.
Installing the Avaya Ethernet Routing Switch 3500 Series
September 2016 Installing Avaya Ethernet Routing Switch 3500 Series 42
Comments on this document? infodev@avaya.com
To Next Page
Loading...
