34 Avaya 3641/3645/6120/6140 IP Wireless Handset SIP Administration Guide June 2012
Configuration sequence
1. Download the latest Avaya 3641/3645/6120/6140 IP Wireless Handset IP
software from http://support.avaya.com.
2. Load the latest version of the SIP software and place it on the designated
server and ensure the server is started. The slnk_cfg.cfg is downloaded first
by the phone, and defines the SIP code files that will be subsequently
downloaded. Ensure that you use the slnk_cfg.cfg file that comes with the
latest version of the SIP code and do not change the order of the files within
slnk_cfg.cfg.
The following six files are included in the typical SIP software package.
Description Filename
Configuration file slnk_cfg.cfg
PHINTL (language translation) pi1400sa.bin
USB downloader pd14udsa.bin
Over-The-Air Downloader (OTADL) pd14odsa.bin
OTADL Shim pd14shsa.bin
Functional (telephony protocol) pd14csa.bin
Note:
See the next chapter Chapter 6: Configure Each Avaya 3641/3645/6120/6140 IP
Wireless Handset for complete information on configuring the handsets as described in
steps 3 through 5 below.
3. [Conditional] If using the 46xxsettings file for remote configuration, set the
parameters in the file. See previous chapter, Chapter 4: System
Configuration, and Appendix B for detailed information. Ensure the
slnk_cfg.cfg GET statement points to the correct filename if it is different than
46xxsettings.txt.
4. Verify the license type is set to SIP (license 56) in the Admin menu. If not,
manually change the license protocol on each handset. If any parameters
have been changed, run Restore Defaults after changing the license type.
See Chapter 6 for exact instructions.
5. Depending on which configuration method you have chosen, set parameters
on each handset.
a. HAT plus Remote: Set minimum parameters for associating to the WLAN:
QoS method: Configure the QoS handset mode to match the AP and
site QoS plan. Follow the VIEW Configuration Guide for the
appropriate make/model of WLAN.
SSID.
Security method: Configure handset security settings to match AP
configuration and RADIUS server settings. If WPA2-Enterprise
To Next Page
Loading...
