Avaya 3641/3645/6120/6140 IP Wireless Handset SIP Administration Guide June 2012 37
Chapter Six: Configuring each Avaya
3641/3645/6120/6140 IP Wireless Handset
To configure the Avaya 3641/3645/6120/6140 IP Wireless Handset, carry out the
following steps:
Power up the handset and download the software. If the handset code needs to be
updated, the SIP code will now download to the handset. The status bar will increment
fully across the display for each function that is being performed in the download
process. Upon completion of the update process, the handset will re-boot with the new
software.
During the second download cycle, the handset receives code from the designated
server for system configuration and for its own settings. Once this second cycle is
complete, the handset is ready for use.
Handset Administration Tool
The Handset Administration Tool is a software utility to automate the configuration of
multiple Avaya 3641/3645/6120/6140 IP Wireless Handsets and perform various
administration tasks. For complete data, please see Avaya 3641/3645/6120/6140 IP
Wireless Handsets Administration Tool.
Remote configuration
After you configure the initial settings either manually or thorough the HAT, the handset
can obtain the remaining parameters from the 46xxsettings.txt file and its
SIP_<username> .txt file.
The Admin (Administration) menu
The Admin menu contains configuration options that are stored locally on each handset.
Each handset is independent, and if you do not want to apply the default settings, the
Admin options must be set in each handset requiring different settings. Default settings
can be found later in this document. The handset Admin menu can be accessed in one
of two ways:
Power off the handset, press and hold the START key. While holding the START
key, press and release the END key. When the Admin menu appears, release the
START key.
Press and release the END key. Press and hold the START key. When the Admin
menu appears, release the START key.
To Next Page
Loading...
