Configure Each Avaya 3641/3645 IP Wireless Handset
Avaya 3641/3645/6120/6140 IP Wireless Handset SIP Administration Guide June 2012 43
1
st
level 2
nd
level 3
rd
level 4
th
level 5
th
level
[Transmit Power]
5mW (7dBm)
10mW (10dBm)
20mW (13dBm)
*30mW (15dBm)
40mW (16dBm)
50mW (17dBm)
100mW (20dBm)
Diagnostics Run Site Survey
Enable Diagnostics
Disable Diagnostics
Syslog Mode *Disabled
Errors
Events
Full
Halt on Error/
*Restart on Error
Restore Defaults
Demos Graphics Demo
* default setting
† Only those 802.11a bands that are available in the selected domain will be listed. See
Appendix A for complete information.
‡ Sub-bands have not been established for the b and b/g mixed or the g-only mode at this
writing. The software has been configured to to accommodate these ranges once established.
Until added, if you select either of these two modes, the Transmit Power options are displayed.
Note:
Modifications of settings under WLAN Settings = “CCX” may get reflected in the
corresponding settings under WLAN Settings = “Custom” or vice versa. If you change
the configuration from “CCX” to “Custom” or vice versa, you must double-check all
settings.
Phone configuration
Language
The Language option is available on both the Admin and Config menus. Select the
desired language from the list. The default language is English.
To Next Page
Loading...
