Avaya 3641 - Chapter Seven: Testing a Handset

Avaya 3641/3645/6120/6140 IP Wireless Handset SIP Administration Guide June 2012 63
Chapter Seven: Testing a handset
Note:
It may be necessary to charge the handset before performing this test. If so, place the
handset into the charger for a minimum of two hours before using it.
Verify proper registration and operation of each handset by performing the following
tests on each handset in an active wireless area.
1. Power on the handset by pressing the END key. A series of messages will be
displayed as the handset connects to the system. The handset should display
the user extension.
2. Place a call and listen to the audio quality. End the call by pressing the END
key.
3. Place a call to the handset and verify ring, answer, clear transmit, and clear
receive audio.
4. Use the softkeys to verify all softkey programmed features on the handset.
5. Press the END key. Any active line indicators should turn off and the
extension number display will return.
If any of these steps fails to operate as described, refer to Chapter 11 Troubleshooting
for corrective action.