Avaya 3641 - Page 74

74 Avaya 3641/3645/6120/6140 IP Wireless Handset SIP Administration Guide June 2012
Softkey Name Displayed during… Press to…
Logs Call Logs Standby mode Open the Call Log menu.
Hold Hold In an active call.
Place the call on hold. The line status
shows when the call is on hold or
when audio is flowing.
Msg Message
Initial dial screen when new
line is selected and a dial
tone is active prior to
entering first character of the
number to be dialed
4
.
Initiate a call to the specified
message center contact address for
retrieval or administration of
voicemail.
Mute Toggle muting In an active call.
Toggle audio transmission to the far
end. The line status shows when
not muted or when muted.
OK OK
Power up registration if
username is not configured
in
Admin menu.
Send the username and password to
the SIP server for authorization to
register the handset.
Redl Redial
Prior to entering the first
character of a dial number.
Redial the last number that was
dialed.
Rej Reject
Incoming call on the selected
line.
Reject the incoming call. The SIP
server will then redirect the call
elsewhere.
Resm Resume
In an active call and you
have placed the call on hold
or in standby mode if any call
is on hold.
Resume a call that was previously
placed on hold or that went on hold
when another line was activated.
Save Save
Entering a dial number as a
forward destination.
Save the dial number as the
forwarding destination for the
selected line.
Symb Symbols
Entering a username or
password.
Entering the digits of a
number.
Select the set of symbols available
on the keypad while entering data.
4
Appears only if MSGNUM is configured. A message center contact address must be defined for the proxy used by
the selected line.