Caution:
Do not place an Avaya Ethernet Power Supply Unit or Avaya Ethernet Redundant Power Supply
on top of the switch. The switch housing cannot support the weight of these units. For a
translation of this statement, see
Translations of safety messages on page 45.
Note:
Avaya switch hardware can vary in size and shape. Your switch might appear different than the
following example figures.
1. Attach the included rubber footpads on the bottom of the switch at the locations.
2. Set the switch on a table or shelf as illustrated below. Allow at least 2 inches (5.1
centimeters) on each side for proper ventilation and at least 5 inches (12.7 centimeters) at
the back for power cord clearance.
Installing the switch on a table or shelf
August 2016 Installing Avaya ERS 4800 Series 11
Comments on this document? infodev@avaya.com
To Next Page
Loading...
