Warning the switch/stack will be reset to factory default
configuration. Do you wish to continue (y/n) ?
2. Enter y to restore the switch to default.
Important:
If you enter restore factory-default [-y], the[-y] parameter instructs the
switch not to prompt for confirmation.
The restore factory-default command is in the privileged exec command mode.
Power specifications
This section describes power specifications for the switches.
Avaya Ethernet Routing Switch 4826GTS, 4826GTS-PWR+,
4850GTS, and 4850GTS-PWR+
The following table describes the regulatory AC power specifications for the ERS 4826GTS,
4826GTS–PWR+, 4850GTS, and 4850GTS-PWR+ switches. It must be noted that regulatory power
specifications are based on the maximum rated capacity of the power supplies and are not based on
typical power consumption which is typically lower.
Table 6: AC power specifications
4826GTS 4826GTS-PWR+ 4850GTS 4850GTS-PWR+
Input Current: 5A/2.5A 12A/6A 5A/2.5A 12A/6A
Input Voltage
(rms):
100 to 240VAC at 50
to 60 Hz
100 to 240VAC at
50 to 60 Hz
100 to 240VAC at
50 to 60 Hz
100 to 240VAC at
50 to 60 Hz
Power
Consumption:
74.3W maximum 149W maximum 94.6W maximum 248W maximum
Thermal Rating: 254 BTU/Hr maximum 508 BTU/Hr
maximum
323 BTU/Hr
maximum
508 BTU/Hr
maximum
Inrush Current: 40A maximum 70A maximum 40A maximum 70A maximum
Turn on Condition: 1 second maximum
after application of AC
power
1 second maximum
after application of
AC power
1 second maximum
after application of
AC power
1 second maximum
after application of
AC power
Important:
12 V output rise time, from 10 to 90 percent, must be the maximum of 50 ms and monotonic under all
defined input and output conditions.
Efficiency: 70 percent minimum 70 percent
minimum
70 percent
minimum
70 percent
minimum
Installing the Avaya Ethernet Routing Switch
August 2016 Installing Avaya ERS 4800 Series 18
Comments on this document? infodev@avaya.com
To Next Page
Loading...
