2. Slide the switch into the rack as illustrated.
3. Insert and tighten the rack-mount screws using a #2 Phillips screwdriver.
Note:
The switch mounting hardware is specific for each switch model. Do not mix screws or brackets
between different switch models.
Cable requirements
The following table describes the cables required for ERS 4800.
Table 3: Switch cable requirements
Required Cable Description
10/100/1000Base TX Ports The interconnect cabling must conform to the Cat5e, Cat6, or Cat6e
specification of the Commercial Building Telecommunications Cabling
Standard, ANSI/TIA/EIA 568-B fitted with an RJ-45 Module jack.
Table continues…
Cable requirements
August 2016 Installing Avaya ERS 4800 Series 13
Comments on this document? infodev@avaya.com
To Next Page
Loading...
