Country and Plug Specification Specifications Typical Plug
Australia:
• AS3112-1981 male plug
• 240VAC
• 50 Hz
• Single phase
Danger:
Using power cords with a proper grounding path
Use only power cords that have a grounding path. Without a proper ground, a person who
touches the switch is in danger of receiving an electrical shock. Lack of a grounding path to the
switch can result in excessive emissions. For a translation of this statement, see Translations of
safety messages on page 45.
Connect power to the back panel
Connect the AC power cord to the back of the switch, and then connect the cord to an AC power
outlet. The following figure shows how to connect the AC power cord to the switch back panel.
Important:
The switch does not have an AC power switch. When you connect the power cord to a suitable,
energized AC power outlet, the switch powers up immediately.
Figure 6: Connecting AC power to the back panel
Installing the Avaya Ethernet Routing Switch
August 2016 Installing Avaya ERS 4800 Series 22
Comments on this document? infodev@avaya.com
To Next Page
Loading...
