1. Check that there are 2 charged AAA batteries inside the remote control.
2. Unplug the codec unit from power.
3. Press the “Back” key and the “OK” key together until the small blue LED on top of the
remote quickly ashes a few times.
4. While the LED light is still ashing, plug the power into the device.
Note: You must keep the remote control close to the unit. If the pairing is successful, the
LED stops ashing. If the pairing fails, disconnect all the cables from the CU, including USB,
and repeat steps 1-4.
N
PAIRING
THE REMOTE CONTROL
To Next Page
Loading...
