DNM-NT/Windows 2000 4.0 Installation and Getting Started
December 2001
Page 26
2
2
Preparing to Install DNM
Customer Pre-Installation Checklist
Customers must complete all of the pre-installation tasks before DNM can be installed or
upgraded.
1 Install or upgrade Windows NT/Windows 2000 platform.
Refer to "System Requirements" on page 24 and the vendor documentation. (See also
Understanding pcAnywhere Security)
2 Connect the DPA computer’s serial connection to the managed nodes.
3 Connect the DPA computer’s TCP/IP connection to the NT/Windows 2000 system
through the local area network (LAN) or the wide area network (WAN). Refer to the
vendor documentation.
4 Verify that the updated PA001 Administration Request form (Rev. 10/01) is
completed and faxed to the Technical Services Center (TSC).
Note: After the DNM installation, system administrators can execute the appropriate
tasks in Chapter 4, "System Administration".
Understanding pcAnywhere Security
Before you install a copy of Symantec's pcAnywhere on any of your computers, read this
section.
!
SECURITY ALERT:
Customers are responsible for the security of their data network and for preventing
unauthorized individuals from accessing it. Therefore, exercise caution when using
To Next Page
Loading...
Need help?
General
