Issue 1 May 2009 23
Avaya - Proprietary. Use pursuant to the terms of your signed agreement or Avaya policy.
DRAFT - January 25, 2009 - 1:38 PM
Chapter 7: Prepare for Configuration
Before you prepare the G430 for configuration, ensure that you load the completed Electronic
Pre-Installation Worksheet onto the laptop. You should also load any CM license and authentication files
and any firmware files that you have prepared onto the laptop.
Preparations for configuration differ depending on whether your G430 contains an S8300 Server. This
chapter describes both options.
Preparing a G430 with an S8300 Server
Use the Avaya Installation Wizard (IW) to configure the G430 with an S8300. If a remote technician is
configuring the G430, see Preparing the G430 with an S8300 for a remote configuration
on page 25.
1. Connect a laptop computer to the Services port of the S8300, using a crossover cable.
2. Make sure the laptop is configured as follows:
● IP Address: 192.11.13.5
● NetMask: 255.255.255.252
● Disable DNS
● Clear the primary WINS and secondary WINS IP Addresses
● Disable the Proxy Server in the Internet Explorer
3. Launch Internet Explorer on the laptop and type the following URL to access the S8300 Server Home
Page: http://192.11.13.6.
The welcome screen for Avaya Integrated Management appears.
4. Click Continue. The Logon screen for Integrated Management appears.
5. Enter the appropriate login name and password.
6. Ask a customer representative for a login name and password that the customer would like for the
superuser login. If you are a business partner, you can also repeat this procedure to add the dadmin
login.
Note:
Note: Make sure the customer can change this login, its password, or its permissions later.
7. From the Integrated Management main menu, select Launch Maintenance Web Interface.
8. From the navigation menu of the Maintenance Web Pages, select Security > Administrator
Accounts.
The Administrator Accounts screen appears.
9. Select Add Login.
To Next Page
