Avaya J100 - Page 226

Parameter name Default
value
Description
AGCHAND 1 Specifies the status of Automatic
Gain Control (AGC) for the
handset.
Value operation:
• 0: Disables AGC for the handset.
• 1: Enables AGC for the handset.
AGCHEAD 1 Specifies the status of Automatic
Gain Control (AGC) for the
headset.
Value operation:
• 0: Disables AGC for the headset.
• 1: Enables AGC for the headset.
AGCSPKR 1 Specifies the status of Automatic
Gain Control (AGC) for the speaker.
Value operation:
• 0: Disables AGC for the speaker.
• 1: Enables AGC for the speaker.
ALLOW_DND_SAC_LINK_CHANGE 0 Specifies whether to enable DND
and SAC link button in the menu.
Value operation:
• 0: To disable DND and SAC link
button.
• 1: To enable DND and SAC link
button.
Note:
Only Avaya J169/J179 IP
Phone supports this feature.
APPNAME_IN_USE Null Used to check which firmware
version is installed on the phone to
perform a corresponding action, for
example:
IF $APPNAME_IN_USE SEQ
4.0.2.0.11 GOTO CROSSGRADE
Table continues…
Customizable parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 226
Comments on this document? infodev@avaya.com