Avaya J100 - Page 238

Parameter name Default
value
Description
DHCPSTAT 3 Specifies whether DHCPv4,
DHCPv6 or both are used if IPv6
support is enabled by IPV6STAT.
Note:
DHCPv4 is always enabled in
IPv4 only and dual mode.
DHCPv4 is disabled in IPv6
only mode.
Value operation:
• 1: run DHCPv4 only.
• 2: run DHCPv6 only.
• 3: run both DHCPv4 and
DHCPv6.
DHCPSTD 0 Specifies whether DHCP complies
with the IETF RFC 2131 standard.
Value operation:
• 0: Continue using the address in
an extended rebinding state.
• 1: Immediately stop using the
address.
DHCPSTDV6 0 Specifies whether DHCPv6 will
comply with the IETF RFC 8415
standard and immediately stop
using an IPv6 address if the
address valid lifetime expires, or
whether it will enter an extended
rebinding state.
Value operation:
• 0: DHCPv6 enters proprietary
extended rebinding state
(continue to use IPv6 address, if
DHCPv6 lease expires).
• 1: DHCPv6 complies with IETF
RFC 8415 standard (immediately
release IPv6 address, if DHCPv6
lease expires).
Table continues…
Customizable parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 238
Comments on this document? infodev@avaya.com