Avaya J100 - Page 290

Parameter name Default
value
Description
PUSHCAP 0000 Controls the modes of individual
Push types.
The value is a 3, 4 or 5 digit
number, of which each digit controls
a Push type and can have a value
of 0, 1 or 2.
Value operation:
• 0: all Push requests are rejected
for this Push type.
• 1: only the Push requests with
Barge mode are accepted for this
Push type.
• 2: the Push requests with Barge
or Normal mode are accepted for
this Push type.
The Push types controlled by each
digit (11111) are the following:
• ||||+- The rightmost digit controls
Top line Push requests.
• |||+-- The next digit to the left
controls display (WML browser)
Push requests.
• ||+--- The next digit to the left
controls receive audio Push
requests.
• |+---- The next digit to the left
controls transmit audio Push
requests.
• +----- The next digit to the left
controls phonexml Push requests.
Note:
The display Push request (the WML
browser) is supported only by the
Avaya J169/J179 IP Phone.
PUSHPORT
80 Specifies the TCP port number to
be used by the HTTP server in the
phone for push.
Valid values are 80 through 65535.
Q
Table continues…
Customizable parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 290
Comments on this document? infodev@avaya.com