Parameter name Default
value
Description
L2QVLAN 0 Specifies the voice VLAN ID to be
used by IP phones.
Valid values are 0 through 4094.
Note:
This parameter can also be
set through:
• Local admin procedure
• A name equal to value pair
in DHCPACK message
• SET command in a settings
file
• DHCP option 43
• LLDP
LANGUAGES Specifies the language files that
must be installed or downloaded to
the phone.
Filenames can be full URL, relative
pathname, or filename.
Valid values can contain 0 to 1096
ASCII characters, including
commas. Filenames must end
in .xml
LLDP_ENABLED 2 Specifies whether LLDP is enabled.
Value operation:
• 0: Disabled
• 1: Enabled
• 2: Enabled, but only begins
transmitting if an LLDP frame is
received.
LOCAL_DIAL_AREA_CODE Specifies if user must dial area
code for calls within same area
code regions.
Value Operations:
• 0: User does not need to dial area
code.
• 1: User need to dial area code.
When enabled, the area code
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 231
Comments on this document? infodev@avaya.com
To Next Page
Loading...
