• Right arrow key
• Left arrow key
6. Press one of the following:
• Save
• OK
Note:
If you do not want your phone to restart and stay in the Manual mode when you switch
Network config from Auto to Manual, press Save.
If you switch Network config from Manual to Auto, press Save and then do either of
the following:
• If the currently-connected network is the same as the pre-configured network that
your administrator has set up, the phone will not restart and stay in the Auto mode.
• If the currently-connected network is not the same as the pre-configured network
that your administrator has set up, the phone will prompt you for permission to
restart before connecting to the pre-configured network.
Related links
Setting the network mode on page 24
Setting the network mode
April 2021 Using Avaya J169 and J179 SIP IP Phones in Open SIP 27
Comments on this document? infodev@avaya.com
To Next Page
Loading...
