Avaya one-X 1603SW - Page 74

Administering Telephone Options
74 Avaya 1603SW-I SIP Deskphones Administrator Guide
!
CAUTION:
CAUTION: PROCPSWD is likely stored on the server “in the clear” and is sent to the
telephone in the clear. Therefore, do not consider PROCPSWD as a
high-security technique to inhibit a sophisticated user from obtaining access to
local procedures.
Administering this password can limit access to all local procedures, including
V I E W. VIEW is a read-only option that allows review of the current telephone
settings.
Note:
Note: There are several ways to change configuration parameters, for example, using
DHCP options, the 46xxsettings file, or using local administrative (manual)
procedures, and a specific procedure exists to determine which value the
telephone should use. Parameter Data Precedence
on page 14 describes the
order in which parameter values are determined.
Table 11: 1603SW-I SIP IP Deskphones Customizeable System Parameters
Parameter Name Default
Value
Description and Value Range
AGCHAND 1 Automatic Gain Control status for handset. Values are
0=disabled, 1=enabled.
AGCSPKR 1 Automatic Gain Control status for speaker. Values are
0=disabled, 1=enabled.
AUTH 0 Authentication flag for settings file download. Values are:
0=secure setting file download is not required
1=secure setting file download is required
BAKLIGHTOFF 120 Number of minutes without display activity to wait before
turning off the backlight. Values range from zero (never
turn off) through 999 minutes (16.65 hours).
CONFIG_SERVER_
SECURE_MODE
0 Indicates whether or not secure communication via
HTTPS is required to access the configuration server.
0 = Use HTTP.
1 = Use HTTPS.
COUNTRY USA Country of operation for specific dial tone generation.
This is a specific text string specifying the country in
which the device operates (e.g. "USA", "France",
Germany"). See Appendix C: Countries With Specific
Network Progress Tones for a list of applicable countries.
DATEFORMAT %m/%d/%y Formatting string defining how to display the date in the
top line and the call log.
1 of 10