Avaya one-X 1603SW - Page 75

Administering Options for the 1603SW-I SIP IP Deskphones
Issue 1 June 2010 75
DHCPSTD 0 DHCP Standard lease violation flag. Indicates whether to
keep the IP Address if there is no response to lease
renewal. If set to “1” (No) the telephone strictly follows
the DHCP standard with respect to giving up IP
Addresses when the DHCP lease expires. If set to “0”
(Yes) the telephone continues using the IP Address until
it detects reset or a conflict (see DHCP Generic Setup
).
DIALPLAN " " (Null) Dial plan for operation with a secondary controller. The
DIALPLAN parameter is used to determine one or more
valid dialstrings. Valid value is 0 to 1023 characters that
define the dial plan. See Setting the Dial Plan on SIP IP
Telephones for more information.
DNSSRVR 0.0.0.0 Text string containing the IP Address of zero or more
DNS servers, in dotted-decimal format, separated by
commas with no intervening spaces (0-255 ASCII
characters, including commas).
DOMAIN " " (Null) Text string containing the domain name to be used when
DNS names in system values are resolved into IP
Addresses. Valid values are 0-255 ASCII characters.
DOT1X 0 Defines the telephone's operational mode for IEEE
802.1X.Valid values are:
0 = Unicast Supplicant operation only, with PAE multicast
pass-through, but without proxy Logoff.
1= Unicast Supplicant operation only, with PAE multicast
pass-through and proxy Logoff.
2= Unicast or multicast Supplicant operation, without
PAE multicast pass-through or proxy Logoff.
DOT1XSTAT 0 IEEE 802.1X status. Enables/disables IEEE 802.1X
function and, if enabled, additionally defines reaction on
received multicast or unicast EAPOL messages. Valid
values are:
0 = Supplicant operation disabled.
1 = Supplicant operation enabled, but responds only to
received unicast EAPOL messages.
2 = Supplicant operation enabled, responds to received
unicast and multicast EAPOL messages.
DSCPAUD 46 Differentiated Services Code Point for audio. Values
range from 0 to 63.
DSCPSIG 34 Differentiated Services Code Point for signaling. Values
range from 0 to 63.
DSTOFFSET 1 Used for daylight saving time calculation in hours. Values
range from 0 to 2.
Table 11: 1603SW-I SIP IP Deskphones Customizeable System Parameters (continued)
Parameter Name Default
Value
Description and Value Range
2 of 10