Administering Telephone Options
78 Avaya 1603SW-I SIP Deskphones Administrator Guide
INGRESS_DTMF_VOL_
LEVEL
-12 RFC 2833 Digit event "volume" level. The power level of
the tone, expressed in dBm0 after dropping the sign.
(from RFC 2833 section 3.5 "Payload Format." Values
are: -20 to -7.
INTER_DIGIT_TIMEOUT 5 This is the timeout that takes place when user stops
inputting digits. The timeout is treated as digit collection
completion, and when it occurs, the application sends out
an invite. Range in seconds of 1 to 10.
L2Q 0 Requests 802.1Q tagging mode (auto/on/off). Values are:
0 = auto
1 = on
2 = off
L2QAUD 6 Layer 2 audio priority value. Range from 0 to 7.
L2QSIG 6 Layer 2 signaling priority value. Range from 0 to 7.
L2QVLAN n/a 802.1Q VLAN Identifier (0 to 4094). Null (" ") is not a valid
value and the value cannot contain spaces. This
parameter is preserved in RAM which survives reset and
stored to flash (as L2QVLAN_INIT) only upon successful
registration. This value is initialized from L2QVLAN_INIT
after power-up. This value will not be initialized from
L2QVLAN_INIT after reset, but can be modified using the
ADDR craft procedure.
LANG0STAT 1 This flag defines, whether or not the built-in English is
offered to the user as selectable item in the language
selection UI menu. At least one other language file must
be downloaded, before "not offering" built-in English.
Values are 0=not offered; 1=selectable.
LANGSYS " " (Null) 0 to 32 ASCII characters. The file name of the system
default language file, if any.
LOGSRVR " " (Null) Syslog server IP or DNS address. 0 to 255 characters:
zero or one IP Addresses in dotted decimal or DNS name
format.
Table 11: 1603SW-I SIP IP Deskphones Customizeable System Parameters (continued)
Parameter Name Default
Value
Description and Value Range
5 of 10
To Next Page
Loading...
