EasyManua.ls Logo

Avaya Scopia XT4300 - Page 120

Avaya Scopia XT4300
215 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5. Set the fields as described in Table 28: Configuring network connectivity on page 120.
Table 28: Configuring network connectivity
Field Name Setting
MTU The MTU, or Maximum Transmission Unit, is the maximum size of data
packets sent around your network. This value must remain consistent for
all network components, including servers like the MCU and Scopia
®
Desktop server, endpoints like XT Series and other network devices like
LDAP servers and network routers.
If you or a remote endpoint transmit at a larger MTU size, packets are
dropped or fragmented. To avoid packet loss or fragmentation, ensure all
network components use the same MTU size. The default MTU size is
1360. For IPv4, set the MTU between 576-1500. For IPv6, set it between
1280-1500.
Speed/Duplex mode Set the speed and transition mode as follows:
Automatic: The XT Series selects the speed and duplex mode. We
recommend this default mode.
Auto - up to 100/Full, Auto - up to 100/Half, Auto - up to 10/Full,
Auto - up to 10/Half: Semi-automatic modes with a specified
maximum.
Manual: Configure the speed and duplex mode manually for your
network and the remote endpoints' settings.
Speed Select the speed of the network port: 10, 100, or 1000 Mbps (manual
configuration only).
Duplex mode Select the data transmission mode that is defined for your network router
or switch, either duplex or half-duplex mode (manual only).
6. From the web interface only, select Save.
7. To tag the XT Series to belong to a particular virtual network (VLAN) ID, select GLAN1/
GLAN2 > VLAN.
8. Set the fields as described in the following table:
Table 29: Designating a VLAN tag
Field Name Setting
Enable Select Yes if your network is split into virtual networks (VLANs) and you
want to assign the XT Series to one of them.
Id Enter the ID of the VLAN to which this unit belongs, between 1 and 4094.
9. To configure the XT Series for 802.1x compliant authentication, select GLAN1/GLAN2 >
802.1x.
10. Set the fields as described in the following table:
Advanced Configuration of the XT Series
120 Avaya Scopia
®
XT Series Deployment Guide April 2015
Comments? infodev@avaya.com

Table of Contents

Other manuals for Avaya Scopia XT4300

Related product manuals