Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 112.
Procedure
1. Access the gatekeeper settings. From the XT Series web interface, select Administrator
Settings > Protocols > H.323 > General. From the endpoint's main menu, select
Configure > Advanced > Protocols > H.323.
Figure 86: Configuring H.323 settings from the web interface
2. Set the fields as described in Table 33: Configuring H.323 settings on page 125.
Table 33: Configuring H.323 settings
Field Name Description
H.323 Name Enter the H.323 alias of this endpoint, used to register the unit with
the gatekeeper. In H.323 calls, this name is displayed on
participant's monitors (for example: John-Smith, or 9th-Floor-Room,
or NY-Office).
E.164 Enter this endpoint's E.164 dial number.
Refuse calls by IP Address Select Yes to allow only endpoints registered to the gatekeeper to
call your endpoint, using your alias or dial number.
3. From the web interface only, select Save.
4. Select H.323 > Gatekeeper.
Configuring Advanced Network Settings
April 2015 Avaya Scopia
®
XT Series Deployment Guide 125
Comments? infodev@avaya.com
To Next Page
Loading...
