95
9. In System section, mark the check box to set the conditions that are caused by system.
- Reboot: when the NVR/DVR system reboot without abnormal condition, the system
will send out the alarm message.
- Abnormal Reboot: when the NVR/DVR system reboot in irregular condition, the
system will send out the alarm message.
- Hard Disk failed: when the hard disk doesn’t work normally, the system will send out
the alarm message.
10. After setting all alarm conditions, click Apply to save the settings.
11. Next, user needs to set the alarm action when alarm has triggered. Please refer to Chapter
2.12.2.
To Next Page
Loading...
