Press and hold the button for 1~2 sec to switch modes among Audio
tracking, Presentation mode, Audio fence and Off.
An icon message (as figure shown) will display on the left upper
screen to indicate in Audio AI status. If you don’t want to see the icon
display, please go to PTZApp 2 or Web setting, find “On Screen
Menu” function and select “Off”.
: Audio tracking and presentation mode
: Audio fence
[Notes]
Audio tracking: Camera pans/tilts (ePTZ) until speaker is
centered before zooming in. The camera moving path will be
shown in the screen. Audio tracking supports up to 7~8m
distance away from the camera.
Presentation mode: This is a combination function of preset
tracking and audio tracking. Please set up preset areas (preset
1~9. Preset 0 is for home position) in the PTZApp 2, IP web page,
or remote control first. When someone speaks within this area,
camera shoots this area. When someone speaks outside of this
area, camera will track this person in view and zoom in. If there is
no more sound and no person’s face is detected outside of this
area after the idle time (based on the idle time interval set up in
PTZApp 2), the camera will shoot on the last triggered preset
area again.
Audio fence: Microphone only picks up the sound within viewing
angle. Adjust the camera viewing area via PTZApp 2 or IP web
page to silence the sound beyond the meeting area.
[Note] All the AI tracking functions, pan, tilt, and zoom in/out will
be disabled while audio fence is on.
To Next Page
Loading...
