2-14 Operator's Handbook
6. Hold the liner while placing one end of the bail in a groove in the liner take-up reel.
Gently rotate the bail counter-clockwise until the other end snaps into the
corresponding groove.
7. Gently slide the bail all the way onto the reel.
8. Turn the reel counter-clockwise to remove any slack in the liner.
9. Close the printhead assembly until you hear it click in to place.
10. Close the exit cover.
11. Close the cover.
12. Press FEED to position the supply under the printhead.
Rest the bail in the groove and rotate it
counter
-clockwise as shown.
To Next Page
Loading...
