Loading Supplies 2-15
Removing a Full Liner Take-Up Roll
The printer alerts you when the liner take-up reel is full. The liner take-up reel holds
approximately half of a roll of liner.
Note: The liner can be removed before the take-up reel is full.
1. Open the cover.
2. Turn the printhead latch to unlock the printhead. Lift the printhead assembly until it
locks into place.
3. Open the exit cover.
4. Gently pull the liner take-up bail off the liner take-up reel.
5. Use scissors to cut the liner in front of the take-up reel.
6. Remove the liner from the take-up reel.
7. Reload supply and continue printing.
Liner Here
To Next Page
Loading...
