Care & Maintenance 5-5
7. Carefully unplug the cable from the printhead.
8. Carefully plug the cable into the new printhead.
9. Align the new printhead with the tabs.
10. Snap the printhead into place.
Note: Make sure the printhead cable does not touch the ribbon roll.
11. Clean the new printhead with a cotton swab dipped in isopropyl alcohol.
12. Let the printhead dry and reload your supplies.
13. Close the printhead assembly and cover.
14. Turn on the printer.
15. Press FEED to position the supply under the printhead.
To Next Page
Loading...
