Loading Supplies 2-1
LOADING SUPPLIES
This chapter describes how to load:
♦ a roll of labels, tags, or string tags
♦ fan-fold supply
♦ peel mode supplies with and without internal liner take-up.
Ask your System Administrator which type of supply to use:
Thermal Direct heat activated supplies that do not use a ribbon for printing
Thermal Transfer standard supplies that require a ribbon for printing
Note: Your System Administrator must set the printer for the correct supply type.
If you are using thermal direct supplies, do not load a ribbon.
Using String Tags
Follow these guidelines for string tags:
♦ maximu m print speed is 6.0 inches per second.
♦ thermal direct printing and a cutter are not supported.
♦ A non-print zone of 0.250 inches (6.4 mm) exists on the string side of the tag.
To Next Page
Loading...
