Getting Started 1-1
GETTING STARTED
The Avery Dennison® Monarch® Tabletop Printer 2 prints on thermal transfer
(ribbon) and thermal direct labels or tags. The printer prints labels continuously (in one
strip) or on-demand (one label at a time). You can print on aperture, die cut, black mark,
or continuous (non-indexed) supplies.
This chapter explains how to:
♦ connect the power cord and communication cable.
♦ use the printer's control panel.
A power cord and ribbon take-up core (may already be on take-up reel) are included.
Keep the box and packaging material in case the printer ever needs repair.
Note: Review the Safety Document included with your printer and the Regulatory
information found on our Web site.
Audience
This Operator's Handbook is for the person who prints and applies labels.
For advanced printer setup (configuring the printer, changing RFID settings), refer to the
System Administrator’s Guide.
Printer Overview
1 Antenna, if installed 4 Liner Tear Edge
2 Cover 5 Navigation Buttons
3 Exit Cover 6 Function Buttons
To Next Page
Loading...
