14
3INSTALLATION AND DEINSTALLATION
2.1 UNPACKING, ASSEMBLING AND CONNECTING THE MACHINE
ALS
20X
256
2.1.3 Setting up
WARNING!
Risk of injury from a tipping over support
stand.
When installing the machine on a support
stand, make sure that it can not tip over.
Fix the support stand onto the ground.
Prerequisites:
Support stand with a tube end providing the following
measures:
– Outer diameter: 60 mm
– Wall thickness: minimum 5 mm
The machines offer three attachment points for mount-
ing to the support:
– Rear side
Requires a fixing bolt to be mounted on the rear side
of the machine. A joint [3B] is used to attach the
fixing bolt to the support. Advantage: The machine
can be inclined both side to side and forwards and
backwards.
– Side plate
Requires a flange [3A] to be mounted on the side
wall of the machine.
– Base plate
Requires a flange [3C] to be mounted on the base of
the machine casing.
To Next Page
Loading...
