04/10 Rev. 5.05-00 USER / SERVICE MANUAL Technical Data
AP5.4 – AP5.6
10
Thermotransfer Ribbon
Ribbon Roll • Winding Direction: Colour-side rolled inwards or outwards
• Roll measurements:
Connections, device data
Protection class „I“
Mains Voltage 100-240 V (AC)
Mains Frequency 50-60 Hz
Power Consumption
• Max. 320W
• In standby mode depending on the equipment 30-40W
Current Consumption max. 3.2A
Interfaces
Detailed information on the interfaces can be found in the Service Manual, top-
ic section Service Electronics , chapter “CPU boards”, “Interfaces”.
External Ø max. 80mm
Core Ø 25mm (1”)
Width
a)
a) Generally counts: The thermal transfer ribbon
must overlap the label 2mm on each side.
For labels wider than 168mm counts: Foil
width = 172mm (max. ribbon width).
AP5.4: 25-114mm
AP5.6: 50-172 mm
Length max. 500m
Interface Details
RS-232
Baud: 1200-115200, 8- bit; suitable connection cord: 1:1
D-Sub 9 extension lead (connector-jack)
RS-422/485
On optional I/O board, D-Sub 15, Baud: 1200-115200,
8-bit
Ethernet
10/100 Base T with TCP/IP, LPD, RawIP printing, DHCP,
HTTPD, FTPD, SNMP
USB (V1.1)
USB-A host port, USB-B device port, Transmission rate
12Mbps
Signal interface On optional I/O board, D-Sub 15
[Tab. 8] Data interfaces at AP5.4/5.6
To Next Page
Loading...
