04/10 Rev. 5.05-00 USER / SERVICE MANUAL Technical Data
AP5.4 – AP5.6
3
Options
Internal Options …should be factory-fitted or installed by a service engineer:
• Reflex Sensor Kit: Light barrier fitting that apart from the transmission sen-
sor, also contains a reflex sensor.
• Label sensor for short labels. Recommended for label length < 30mm.
• Internal rewinder kit: To retrofit the internal rewinder; contains the rewinder
as well as the driver board and material guide
• I/O board: RS-422/485 interface, signal interface
External Options …do not require any special alterations to the printer:
• Cutter (required printer: AP5.4/5.6 peripheral)
• AP5.4 only: (External) rewinder for material rolls with 38mm (1.5”), 75 mm
(3”) or 100mm (4”) cores (required printer: AP5.4 peripheral)
• Keyboard for standalone operation
• Foot switch for foot-operated label dispensing
• Dispensing edge (required printer: AP5.4/5.6 „basic“ or „peripheral“ with
internal rewinder)
To Next Page
Loading...
