04/10 Rev. 5.05-00 USER / SERVICE MANUAL Technical Data
AP5.4 – AP5.6
2
Application, Device Types
Application
• Monotone printing of label stock for thermal and thermotransfer processes
• Printing on different materials, e.g. cardboard or self-adhesive labels,
which are suitable for thermal- or thermotransfer printing
• Processing roll and fan-folded material
• Resolution: 8.0 or 11.8Dot/mm (203 or 300dpi)
• Print speed up to 200mm/sec (8”/s)
• Print width:
– AP 5.6: up to 168mm
– AP 5.4: up to 105mm
• Interfaces: RS-232, USB,, Ethernet, and connection for foot switch
Device types
AP5.4 and AP5.6 are available in 4 versions:
Basic AP5.4/5.6 equipped with serial, USB and Ethernet interface and SD-card slot.
Possible upgrade to „peripheral“ version.
The following options can be integrated:
• Reflex sensor (top and/or bottom)
• I/O board (signal interface and additional serial interface)
Peripheral Like the AP5.4/5.6 basic, but with capability to add the following options:
• External rewinder (for AP5.4 only)
• Cutter
„Basic dispenser“ or
„peripheral dispenser“
AP5.4/5.6 with additional built-in internal rewinder. In connection with an op-
tional dispensing edge, this printer can also be used as a dispenser. If the dis-
pensing edge is replaced by a deflection plate, the printed labels are not
dispensed, but rewound together with the backing paper.
To Next Page
Loading...
