12/08 Rev. 5.01-01 USER MANUAL Commissioning & Operation
AP7.t
11
The status message 5001 (shown above) occurs when for example the
printer is set for punched label material, but continuous form material without
punches has been inserted. In this case, the printer will continue to feed the
material for a few seconds before it generates an error message.
P More information on status reports and a detailed list of all messages can be
found under Status Reports
.
Standalone
mode
In standalone mode, print jobs are not transferred but saved on a CF card.
They are started directly from the printer’s control panel or via a connected
keyboard.
P Further information about standalone mode can be found in Special
Applications.
To Next Page
Loading...
